Blogs » Shopping » Procedure for casting in rail shoulders?

Procedure for casting in rail shoulders?

  • Procedure for casting in rail shoulders? We have made a brief introduction to this problem before, but found that there are still many customers who do not understand. Just today also take this opportunity to explain to you. I hope it can bring good help to the relevant people.

    cast in rail shoulders is also a more widely used equipment. It plays a very important role in application. in fact, cast in rail shoulders for the same power transmission, hydraulic transmission device small size, light weight, small inertia, compact structure, flexible layout. As a mechanical equipment, it is also necessary to master its operating procedures when it is used. That way we won't damage it. First of all, the thing to do is to switch on the power supply, open the test software, start the servo oil pump and the clamp oil pump. Then raise the piston for a distance (about 5mm- 10mm). Once all of this is done you have to enter the sample information according to the experiment requirements, complete and return. According to the programming control, according to the sample requirements to write automatic control program, as long as it is operated in the correct way, there will be no problem. Moreover, the test force of cast in rail shoulders is adjusted to zero, and the peak value is cleared (the sample shall not be cleared after clamping). You can then press the "Trial Start" button to start the trial. The staff must be clear that after the end of its experiment, go down the sample and make the piston reset. Then to analyze, save the test data, print the test report.

    cast in rail shoulders In addition to mastering its procedures, there are a few considerations. For example, cast in rail shoulders it is not allowed to load with the lower beam lifting when working. It is not allowed to lift the lower beam under load. And here you should understand that if there is an abnormal situation in the experiment, then at this time should first open the servo valve oil return unloading, after the load is removed, and then open the fast oil return valve oil return, do not allow to start the oil pump under high pressure or check the reason. The products produced by our company have attracted a lot of customers because of their beautiful appearance. Of course, the process here is rigorous and meticulous, the price is reasonable and the after-sales service is perfect, and has been well received by users all over the years. If you do not understand the place can call our phone at any time to consult, enter the website you can see the way to contact, you can also consult online customer service staff. Will help everyone to solve some problems in the quotation method.

    cast in rail shoulders https://www.hbrailwayfastening.com/Rail-Cast-in-Rail-Shoulders.html